Find a Distributor & Service

Heavy Duty Stormtite™ Insulated Springless Service Doors 625S

EverServe™ Model 625S

This heavy duty Stormtite™ insulated springless service door delivers security, reliability and ease of serviceability and is best suited for applications that require protection against weather extremes. The insulated slats provide climate control as well as sound reduction, while perimeter seals provide additional protection from weather.

Rolling Steel Doors

/rolling-steel-service-doors

Where to Buy

/distributor-locator

Features

Standard Max Width
up to 30' (9246 mm) depending on gauge and slat type

Standard Max Height
up to 20' (6096 mm) depending on gauge and slat type

Mounting
Interior or exterior face of wall

Control panel
Electronic controller with microprocessor self-diagnostics. Digital readout indicates door action, alarm conditions, and fault conditions. Time delay self-close timer and non-resettable cycle counter is included. One open/close/stop push button station integrated in control panel. Enclosure is IP54 rated (NEMA 3 equivalent).

Curtain
Galvanized steel interlocking roll-formed slats, end locks attached to prevent lateral movement; Insulated flat profile (F-265i) for doors up to 30' wide - front and back slats 24 gauge. Slat cavity shall be filled with CFC-free, foamed in-place, polyurethane insulation

Curtain finish
Gray, Tan, White or Brown polyester top coat

Bottom bar
Two PowderGuard^® Premium powder coated black angles (min. thickness 3/16”) with weatherstrip

Hood
24-gauge galvanized steel primed; motor and end cover provided

Brackets
Min. ¼” hot rolled primed, PowderGuard^® Premium powder coated black steel

Insulation
R-value* of 7.71 for energy-efficiency. U-value of .13 and STC rating of 21

Guides
Three structural steel angles PowderGuard^® Premium powder coated black; With high cycle UHMW wear strip

Door roll
Direct driven, springless roll with integrated shafts; self-aligning grease-able sealed bearings; door does not require counterbalance device

Stormtite™ perimeter seal system
Exterior guide seal, interior hood baffle, bottom astragal

Safety devices
Built-in braking mechanism provides additional peace-of-mind against uncontrolled curtain travel.
Photoelectric safety sensors with guards - provide obstruction monitoring during door operation to help prevent injury and damage

Operation
Direct drive integrated gear/motor/brake assembly; Drive assembly and limit sensors are factory pre-assembled; Manual hand chain for power outage. Horsepower appropriate to door size/weight; 230V AC 3-phase motor (operating range 208-245V)

Actuator
Single open/close/stop push button station incorporated into control panel

Wind load
20 psf

Warranty
36 month limited warranty coverage on door system

Door Options

Motor options: Available for supply voltages 220-240V AC 1-phase; 440-480V AC or 575V AC 3-phase (both 440-480 and 575V AC require transformer).
Flat profile type F-265i for doors up to 30' wide. Available in: [Front Slat] 22, 20, 18 gauge galvanized steel; 22, 20 gauge stainless steel; 18 gauge (.040") aluminum [Back Slat] 22 gauge steel; 24 gauge stainless steel; 22 gauge (.024") aluminum*
Bottom bar also available in galvanized steel, stainless steel and aluminum
Guide options include galvanized steel, power-coated steel
Hood available in powder coat, stainless steel and aluminum; sloped hood also available
Brackets also available in powder coat, galvanized steel
IP65 (NEMA 4/4X equivalent) control panel
Sensing edge for improved safety
Additional set of photoelectric sensors
Optional push buttons, loop detectors, radio control, motion detectors or any combination thereof available for door operation/control
PowderGuard^® Premium powder coat and PowderGuard^® Max hardened powder coat available in approximately 200 colors as well as color-matching to specification
PowderGuard^® Textured Finish: Industrial textured powder coat provides a thicker, more scratch resistant coat for added product protection on guides, bottom bar and head plate
Uniformly spaced glazed acrylic vision lites available in 10” x 1”
High wind load options available

*Consult factory for specific slat profile and gauge width limits.

Colors

Standard Exterior Color

White
Gray
Tan
Brown

Actual door color may vary from the digital representation shown here. Actual color samples are available by request through your Overhead Door™ Distributor.

Powder Coat Color Options

PowderGuard^® Premium powder coat options are available in approximately 200 colors as well as custom matching to specification. PowderGuard^® Textured Finish: Industrial textured powder coat available in 11 colors provides a thicker, more scratch resistant coat for added product protection on guides, bottom bar and head plate.

Documents