HomeLink® Programming for Garage Door Opener
5 Steps To Program Your HomeLink® System
Note: Some vehicles may require the ignition to be turned on or the vehicle running to program the HomeLink® transceiver. To program a rolling code compatible HomeLink® system, please follow these steps.
If you have a newer garage door opener from Overhead Door® garage opener, including a Destiny®, Odyssey®, or Legacy® 850 and the first 5 digits of the serial numbers are 11291 or greater please find our HomeLink® Programming instructions for these newer garage door opener models.
For any serial number smaller than 11291, the following programming instructions are what you will need.
- Press and hold the two outside buttons on the HomeLink® system until the LED starts to blink, release buttons.
- Press and hold the desired HomeLink® button and the transmit button on your rolling code transmitter at the same time until the HomeLink® LED changes from a slow blink to a rapid blink. (Your system is now programmed)
- Locate the learn code button on your garage door opener. (These are located under the light cover or on the rear panel depending on the model)
- Press the learn code button on the garage door opener, and a red LED will start to blink. (You will have 30 seconds to complete programming)
- While the LED on the garage door opener is blinking, return to the vehicle and press the pre-programmed HomeLink® button 4 times. (Or until the garage door operates).
HomeLink® is a registered trademark of Gentex Corporation. For system problems call 1-800-355-3515 or visit their website.
